Tweet
Hi
I am trying to run a multistep problem and I am using a different load controller for each step. I ran my case and it converge, which I was thrilled about after struggling with the mesh for some time. However I come to find out, the problem is resetting after each step. So rather than having a 20 step problem, I have 20, one step problems. I am confused because the endpoint from one step should be the starting point for another step. I have no gaps in my LC definitions in terms of time and I have an end value of 1 for each load. Also the end time coincides with the end result from the timesteps in the step section. I am at a loss....
I have attached my problem
Thanks in advance,
M
I am trying to run a multistep problem and I am using a different load controller for each step. I ran my case and it converge, which I was thrilled about after struggling with the mesh for some time. However I come to find out, the problem is resetting after each step. So rather than having a 20 step problem, I have 20, one step problems. I am confused because the endpoint from one step should be the starting point for another step. I have no gaps in my LC definitions in terms of time and I have an end value of 1 for each load. Also the end time coincides with the end result from the timesteps in the step section. I am at a loss....
I have attached my problem
Thanks in advance,
M
Comment