Hi,
I've just started using Preview and I tried to go through the example on two block compression (co35), however when i run the simulation in postview the top block simply moves upwards (in the positive z-direction) instead of compressing the bottom block. How do I set the boundary condition to make the block move in the negative z-direction?
Thanks,
Hugh
I've just started using Preview and I tried to go through the example on two block compression (co35), however when i run the simulation in postview the top block simply moves upwards (in the positive z-direction) instead of compressing the bottom block. How do I set the boundary condition to make the block move in the negative z-direction?
Thanks,
Hugh
Comment