Greetings,
I would like to apply a nodal force on a specific nodeset. I define the force magnitude using a loadcurve. The problem is that when i am trying to preview the loadcurve using the FebioStudio curve editor then a simple ramp curve expanding form points (0,0) to (1,1) is displayed.
The xml format is the following:
where the lc = "1" defines the loadcurve id, and the loadcurve is defined as:
I wonder if i made a mistake defining the nodal load or this is simple a curve editor issue.
Best regards,
Konstantinos
I would like to apply a nodal force on a specific nodeset. I define the force magnitude using a loadcurve. The problem is that when i am trying to preview the loadcurve using the FebioStudio curve editor then a simple ramp curve expanding form points (0,0) to (1,1) is displayed.
The xml format is the following:
HTML Code:
<nodal_load bc="x" node_set="nodeset1"> <scale lc="1">1.0</scale> </nodal_load>
HTML Code:
<loadcurve id="1" type="smooth"> <point>0,0</point> <point>0.016667,0.00010073</point> <point>0.033333,7.2197e-05</point> <point>0.05,5.7076e-05</point> <point>0.066667,9.0277e-05</point> <point>0.083333,0.00016695</point> <point>0.1,0.00014443</point> <point>0.11667,0.00014377</point> <point>0.13333,0.00013635</point> <point>0.15,0.00014744</point> <point>0.16667,0.00016933</point> <point>0.18333,0.0002296</point> <point>0.2,0.00034064</point> <point>0.21667,0.00070066</point> <point>0.23333,0.037317</point> <point>0.25,0.17064</point> ...... </loadcurve>
Best regards,
Konstantinos
Comment