Hi,
I am attempting to simulate the filling of a small bladder in multiple stages.
I have setup a test case that uses a bladder with a urethra and 2 ureters. The urethra is used for fluid inflow (as per a physical experiment). The ureters have been designated the exits but with very high fluid flow resistance so that the bladder fills. I can't get the model to converge. A previous test using a cylinder with one end the entry and the other end as the exit did work.
I have attached feb files for both the successful cylinder test and the following bladder test that I want to work the same way.
The goal is to have the final bladder model fill over longer periods of time with a rest interspersed between each filling period (e.g. 5 to 10 mm^3 fill over 2 mins, followed by 10 min rest, repeated multiple times until the bladder is fully distended).
cylinder_flow_test_6.zipbladder3_3.zip
Any guidance that could be offered to help me would be appreciated.
Thanks,
Harley.
I am attempting to simulate the filling of a small bladder in multiple stages.
I have setup a test case that uses a bladder with a urethra and 2 ureters. The urethra is used for fluid inflow (as per a physical experiment). The ureters have been designated the exits but with very high fluid flow resistance so that the bladder fills. I can't get the model to converge. A previous test using a cylinder with one end the entry and the other end as the exit did work.
I have attached feb files for both the successful cylinder test and the following bladder test that I want to work the same way.
The goal is to have the final bladder model fill over longer periods of time with a rest interspersed between each filling period (e.g. 5 to 10 mm^3 fill over 2 mins, followed by 10 min rest, repeated multiple times until the bladder is fully distended).
cylinder_flow_test_6.zipbladder3_3.zip
Any guidance that could be offered to help me would be appreciated.
Thanks,
Harley.
Comment