Hi Maryrose,
Thanks, I still see distinct values of the traction components on my computer.
I still can't figure out why you are getting different results, so I would suggest you try the following:
(1) Using my test model, please try to apply only one non-zero traction component at a time (i.e., (0.5,0,0), (0,0.25,0) and (0,0,-0.1)). In each case the deformation of the block should be consistent with the applied traction (leaning along x, leaning along y, compressing along z, with magnitudes proportional to the applied traction).
(2) Please repeat these analyses with the FEBio 2.9 executable downloaded from the febio.org website as well as with your compiled version and compare the results.
Please let me know what you find for both (1) and (2). (In my case, the FEBio 2.9.1 executable downloaded from febio.org gives me the expected behavior for (1).) If you notice differences between your compiled version and the downloaded executable, we can focus on your method of compiling the code (unless you made other changes to the code?).
Best,
Gerard
Thanks, I still see distinct values of the traction components on my computer.
I still can't figure out why you are getting different results, so I would suggest you try the following:
(1) Using my test model, please try to apply only one non-zero traction component at a time (i.e., (0.5,0,0), (0,0.25,0) and (0,0,-0.1)). In each case the deformation of the block should be consistent with the applied traction (leaning along x, leaning along y, compressing along z, with magnitudes proportional to the applied traction).
(2) Please repeat these analyses with the FEBio 2.9 executable downloaded from the febio.org website as well as with your compiled version and compare the results.
Please let me know what you find for both (1) and (2). (In my case, the FEBio 2.9.1 executable downloaded from febio.org gives me the expected behavior for (1).) If you notice differences between your compiled version and the downloaded executable, we can focus on your method of compiling the code (unless you made other changes to the code?).
Best,
Gerard
Comment