Hi there
I got the preblem for importing STL file.
I tried to create a knee joint model based on the MR image.
The model was created by Mimics and exported as an STL file.
Then, I imported the model to PreView. It seems did well.
But, the model doesn't have (be defined) the edge and the surface.
What should I do for defining the edge and surface?
The model was created based on the single sagittal plane slice of MR image.
I attached the STL file and PreView file.
If you need more information and/or data, I will be able to upload.
Best regards
Satoshi
I got the preblem for importing STL file.
I tried to create a knee joint model based on the MR image.
The model was created by Mimics and exported as an STL file.
Then, I imported the model to PreView. It seems did well.
But, the model doesn't have (be defined) the edge and the surface.
What should I do for defining the edge and surface?
The model was created based on the single sagittal plane slice of MR image.
I attached the STL file and PreView file.
If you need more information and/or data, I will be able to upload.
Best regards
Satoshi