Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: 'Ogden unconstrained'+'fibre-exp-pow' problem

  1. #11
    Join Date
    Nov 2007
    Location
    Salt Lake City, UTAH
    Posts
    2,146

    Default

    Hi Nat,

    Yes, in general you would create different loadcurves for boundary conditions of different steps. The reason is that each step has a different time range and thus load curves used in a particular step must be defined over the same time range. Thus, for the six steps defined above, you would a different load curve and each load curve would match the time range of the corresponding step.

    Cheers,

    Steve
    Department of Bioengineering, University of Utah
    Scientific Computing and Imaging institute, University of Utah

  2. #12
    Join Date
    Jan 2019
    Location
    Gold Coast, Australia
    Posts
    72

    Default

    Hi Steve,

    Do you mean that firstly, I have to plot time versus displacements x,y,z and time versus rotations in Rx,Ry,Rz. Based on this determine the load curves for a particular step over the same time range? I found only some explanation of load curves in manual of Febio, where else can I find more profound explanation of load curve definition?

    Cheers,
    Nat

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •