Hi all,
I have been unable to "bend" (about an axis) an editable Gmsh mesh.
(see file attached).
I used the 'add modifier' function, and chose "bend" (to bend the mesh
by 30 degrees about the X-axis), but was unsuccessful.
Is there a way to bend an imported Gmsh mesh?
Thanks.
I have been unable to "bend" (about an axis) an editable Gmsh mesh.
(see file attached).
I used the 'add modifier' function, and chose "bend" (to bend the mesh
by 30 degrees about the X-axis), but was unsuccessful.
Is there a way to bend an imported Gmsh mesh?
Thanks.
Comment